Hi Chaps

Wondered if you could help.

 

Ive a Scantronics 9651 with engineers codes etc.

 

i recently moved a PR Sensor for decorating and tripped a fuse on the board. While out of use (awaiting fuses) I took the opportunity to remove the keypad and clean the contacts as several buttons were not working properly.  
 

Afterwards I changed the relevant fuse and despite having codes I’m unable to reset my system from a Bell Temper & Aux  DC Fault.   Any tips would be gratefully appreciated.

 

many thanks 

Steve 

Do you have a multimeter OP?

 

Also send us a picture of your PCB so we can see the exact model (though if it has fuses suspect which one it will be) but good to check.

On 01/03/2020 at 11:49, Logan said:

Did you check the other fuses

Hi

Yes, two fuses on the circuit board and the  remaining two all intact.

steve

44 minutes ago, Steve89 said:

Hi

Yes, two fuses on the circuit board and the  remaining two all intact.

steve

Do one thing at a time 

 

First disconnect the pirs etc from the 12v aux  , you need keypad on tho of course and link the bell tamper 

 

This should prove panel is working if those faults clear