Gardtec 300 series panel wired to Honeywell AD6

[Richard Willetts]

Hi all

I am trying to connect a Gardtec 300 sieries to a Honeywell AD6 and have 2 issues which I think are related.

The first is when an alarm is triggered when testing the internal sounder and the strobe flashes out side but no bell/siren, also the 2 led`s are not flashing from side to side but one is glowing constantly.Have I got the BELL- AND BELL HOLD THE WRONG WAY ROUND

 

I have wired the panel as follows

Panel                       AD6                                               

SAB tamper   to     TR-

BELL-              to     S-

BELL+             to     V+ 

BELL HOLD    to     V-

STROBE-         to     ST-

STROBE+ NOT CONNECTED

 

thanks 

Richard

 

[sixwheeledbeast]

Are the tampers on the box closed correctly?

Don't know the panel or the bell too well but seems right.

[al-yeti]

2 hours ago, Richard Willetts said:

Hi all

I am trying to connect a Gardtec 300 sieries to a Honeywell AD6 and have 2 issues which I think are related.

The first is when an alarm is triggered when testing the internal sounder and the strobe flashes out side but no bell/siren, also the 2 led`s are not flashing from side to side but one is glowing constantly.Have I got the BELL- AND BELL HOLD THE WRONG WAY ROUND

 

I have wired the panel as follows

Panel                       AD6                                               

SAB tamper   to     TR-

BELL-              to     S-

BELL+             to     V+ 

BELL HOLD    to     V-

STROBE-         to     ST-

STROBE+ NOT CONNECTED

 

thanks 

Richard

 

Out of curiosity

 

Swap the strobe- and bell- wires at the panel only , do same test you said you did and what is the difference?

 

As swb said maybe tampers not closed or some panels require a resistor on the tamper circuit , I don't know this panel either 

Ps you sure it's not aG6 bellbox?

[james.wilson]

The leds not flashing says to me Sab tamper not closed