ElecTech Posted June 13, 2018 Share Posted June 13, 2018 Had a call out today to a ZX1SE, long story short water ingress into a Morley call point (loop is Morley protocol). I have removed the device physically of the loop & from the panel until we get the replacement unit tomorrow... Weird thing is on the panel, when I reset the panel, the next device on the loop (next to the call point in question) goes into fire... Address 108 (water ingress device) - once removed of the loop, 109 goes into fire, remove 109, 110 goes into fire & so on... Also get the odd corrupt signal too, Could the water of damaged the loop card/panel in anyway? Any suggestions would be great. Link to comment https://www.thesecurityinstaller.co.uk/community/topic/42150-morley-zx1se-issues/ Share on other sites More sharing options...
BUSTER Posted June 14, 2018 Share Posted June 14, 2018 Not heard of that, fitted quiet a few ZX panels but didn’t know Morley had their own protocol so I have learned something today Any comments / opinions posted are my opinion only and do not represent those of my employer or Company Link to comment https://www.thesecurityinstaller.co.uk/community/topic/42150-morley-zx1se-issues/#findComment-477092 Share on other sites More sharing options...
sjsturner Posted June 14, 2018 Share Posted June 14, 2018 I assume the loop wiring is clean and not compromised? sounds like more damage, checked the screens? Any earth faults? Link to comment https://www.thesecurityinstaller.co.uk/community/topic/42150-morley-zx1se-issues/#findComment-477101 Share on other sites More sharing options...
grantc Posted June 15, 2018 Share Posted June 15, 2018 Tried linking the loop out completely to see if it sits fault/fire free? That would rule out the loop card. Grant Link to comment https://www.thesecurityinstaller.co.uk/community/topic/42150-morley-zx1se-issues/#findComment-477110 Share on other sites More sharing options...
sparky999 Posted September 1, 2018 Share Posted September 1, 2018 Just seen this post not been here for a while sounds like water ingression has caused corruption if you have a download then wipe the system re-upload Peter Robinson Freelance M:07889038650 Link to comment https://www.thesecurityinstaller.co.uk/community/topic/42150-morley-zx1se-issues/#findComment-478932 Share on other sites More sharing options...
al-yeti Posted September 1, 2018 Share Posted September 1, 2018 (edited) 49 minutes ago, sparky999 said: Just seen this post not been here for a while sounds like water ingression has caused corruption if you have a download then wipe the system re-upload Water ingress where? Just asking lol because that's what op already said .... Edited September 1, 2018 by al-yeti Link to comment https://www.thesecurityinstaller.co.uk/community/topic/42150-morley-zx1se-issues/#findComment-478935 Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now