Does anyone have an ADE Opus 42 printer taht they don't want? I need one for my Accenta Mercury. I'd pay postage 

 

 

Depends, vapourware or just a rebadged Casio etc...?

5 minutes ago, datadiffusion said:

Depends, vapourware or just a rebadged Casio etc...?

Hmmm, I don't know. Whatever works with it? Do you have a compatible printer? I don't mind any brand  

No binned my 9500 etc.. printers a while back.

I've never seen an opus 42 or cpa6

 

I acquired datac printer from scantronic multiscan, 

 

In my experience a branch of national co. or large regional installer might have one 7300 nvm programmer or a logging printer

3 minutes ago, datadiffusion said:

No binned my 9500 etc.. printers a while back.

 

Shame, I can't seem to find anything like it on eBay, it only requires 3 wires to connect to the panel. 

2 minutes ago, MrHappy said:

I've never seen an opus 42 or cpa6

 

I acquired datac printer from scantronic multiscan, 

 

In my experience a branch of national co. or large regional installer might have one 7300 nvm programmer or a logging printer

 

Do you know if anything like these are still made, for panels like the Galaxy?? 

 

When I took out a Menvier panel a few years back, there was a till roll inside where back in 1996 the original Co. had printed out

the programming data, just in case I suppose! 

most panel manufacturer list printer interfaces,

 

bet they sell less than they are churches saudi

I think this is the same as my datac printer?

 

https://www.checkline.eu/products/126322/large/126322.jpg

1 hour ago, datadiffusion said:

When I took out a Menvier panel a few years back, there was a till roll inside where back in 1996 the original Co. had printed out

the programming data, just in case I suppose! 

 

1 hour ago, MrHappy said:

most panel manufacturer list printer interfaces,

 

bet they sell less than they are churches saudi

I think this is the same as my datac printer?

 

https://www.checkline.eu/products/126322/large/126322.jpg

 

Thanks for the reply, guys  This may be a bit off topic from this, but have you taken out any dead panels? Like an Optima, Accenta or something simple like that? I want to pull apart an alarm circuit board, to see in detail how it works, and how it has been programmed. I also need a casing for my Accenta Mercury panel, any help is much appreciated  

35 minutes ago, Gabs said:

 

 

Thanks for the reply, guys  This may be a bit off topic from this, but have you taken out any dead panels? Like an Optima, Accenta or something simple like that? I want to pull apart an alarm circuit board, to see in detail how it works, and how it has been programmed. I also need a casing for my Accenta Mercury panel, any help is much appreciated  

Are used ones not cheap on eBay?