Jump to content
Security Installer Community

Texecom elite 48W onboard exp fault


Recommended Posts

Hi all, Im just programming up a some texecom 48-w kit2's for jobs this week and one of the panels has no response from the tx/rx LED's on the onboard exp1 side of the board and nothing from the wireless signal LED's either.

also in confirm devices this isn't being seen by the panel?

do you think I've fell unlucky and got a faulty panel?

thanks in advance 

50378603619__046443B7-DADF-4BB8-A47D-0E89A642FFD7.MOV

Edited by AlarmDoctorBrigg
Link to comment
Share on other sites

1 minute ago, sixwheeledbeast said:

Not necessarily there maybe a short on the data

This is being done with the keypad on a fly lead (no other wires connected to the panel) except mains to power it for programming purposes as learning the ricochet devices and programming the part sets up.

the other 3 kits I had to do have been programmed and reboxed ready for installing.

just this one kit when powered up has no LED's lit on the right hand side of the board like the other 3 kits did.

even after defaulting the nvm and clean starting.

no shorts on the data on my engineer keypad I use it daily!

 

the wireless expander is onboard on the 48W and is not even seen in the expander menu and not seen when confirming devices (only the connected keypad)

 

Link to comment
Share on other sites

To be honest I think I've just been unlucky with this one.

ive never had an issue in the past, just power up on mains, program and rebox them for install.

this is the first time I've had one not respond. With it being all one pcb aswell, unless faulty there should be no reason for the LED's not to power up out of the box.

Link to comment
Share on other sites

Lmfao eBay purchase, :lol: No i only purchase off security warehouse 

All the switches all on (as was the other kit I've just programmed - it's the kit002 all out the box setup from Texecom, link on commission mode for ricochet device learning (I've been using Texecom equipment for last 12 years)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.