hi guys hope your well.

here is 1 for you,

honeywell GD96.

network 1 has 1 leg with 1 touch screen and 2 rios on it.

network 2 has 2 leds on it, 1 is wired to a RF portal which is 3 feet away from panel and the other leg has 1 touch screen and 2 rios on it. the 680 resistor is disabled in the panel on network 2.

customer reported that it was showing faults with missing mods.

went to site and did a RRS, it was showing it had lots communication with the touch screen and 2 rios on network 2 but it still had 100% communication with the RF portal.

everything on network 2 was wired and live but not communicating with the panel

RRS showed memory was ok and all items on network 1 was 100%.

I rebooted the panel and all was then fine and is still working fine 2 days later but still no idea as to why this happend? am i missing anything here?

 

Thanks Dan

 

Sounds like power or cable issue

Hi James.

Going back to site on friday to check it over again.

I would check the battery, if the mains dips out for only a few seconds and the battery is not up to the job, could cause the micro to get "stuck", just a thought

Hi Adrian.

New batt fitted last month.

Hi Adrian.

New batt fitted last month.

Doesn't mean it's any good

Doesn't mean it's any good

Was thinking the same, had new yuasa fail after a week the other day!

Edited July 16, 201312 yr by sjsturner

Was thinking the same, had new yuasa fail after a week the other day!

 If the issue has only just presented for the first time, and the battery has been changed, seems like too much of a coincidence to me

New battery today, plugged onto g2.

Panel went crazy . Bells ruining date and time reset. Thought I'd messed up polarity at first.

Tested for voltage and had 4v and wouldn't power meter. Gave it a shake and it sounded like a baby's rattle. Very strange.

@ adrian I hate coincidence lol.

Its being monitored at the mo for that reason.

Edited July 16, 201312 yr by sjsturner