Can anybody help please?

I have an Accenta 8 EP 416 led keypad. Before Xmas we converted garage to a bedroom so today was trying to add garage sensor to the night omit program.

now it’s not doing anything and the spanner lights illuminated it’s stopped responding to anything the only light not illuminated is the sos one.

Stuck in engineering menu or some tamper and maybe fuse blown?

Time to check over everything you have done and get the multimeter out.

Thankyou mate

I’ll check fuse then any idea where it will be?

On the PCB of the control panel, if no sensors light up that would be a good indication.

 

No just found fuse it’s fine,all sensors light up fine I’ve obviously done something wrong as there’s a load beep when I try and press the  4th number of any code. The 3 numbers go in fine and there seems to be an error noise on the 4th number.

In the programming menu then by the sounds of it.

Thanks for your help

Recycle the power and start again would be the easiest if you dont know what you're doing 

Or press reset a few times