Can anyone recommend the best way to get control / notifications from Galaxy Flex V3 panel on mobile device?

 

Panel has ethernet module and gsm module installed.

 

I have also got the got GX Remote app on phone (not setup).

 

Reading the above post I am now left wondering whether using Selfmon is the better way to go?

 

Any advice gratefully received.

Edited February 15, 20206 yr by sixwheeledbeast
Split this, best as a seperate thread

Either way will work. The Galaxy GX app will provide free push notifications. Selfmon enables granular control for different push/sms/email/voice messages to different devices/people along with line path monitoring and ddns.

Thanks for that.

 

Is it correct that the RSS software is required to program the panel for selfmon or GX?

No but its a lot easier

1 minute ago, Logan said:

Is it just me  but is the most common panel on this forum that people have a question about is galaxy 

Just you , unless you mean galaxy in general

2 minutes ago, Logan said:

Yes galaxy in general 

Probably because so much is available on eBay aswell , thousands were installed by ADT 

 

Over the years I think it will become visonic question instead 

 

Most of the junk will be at your house 

 

Most of TSI would have retired except H who might not give up stalking 

Just now, Logan said:

To me galaxy's are great panels for commercial and industrial but not really suited for domestic use 

No you are wrong 

 

Flex and G2 etc not good commercial you need the dimension range for that , perhaps the larger flex might do it don't know 

 

Just my opinion

You won't have a Gal 90 doubt you have a mk2 keypad that's exec era

oh and the keypad is a 6?