Andy cb Posted October 26, 2019 Author Share Posted October 26, 2019 20 hours ago, al-yeti said: You can disconnect the tamper aswell and use that on a tamper circuit Either way you can't use that circuit board on the speaker output simple Ok I think I need to return it am I right I’m needing to CQR soint1 I posted about earlier Quote Link to comment Share on other sites More sharing options...
Andy cb Posted October 26, 2019 Author Share Posted October 26, 2019 Al-yeti I know what others have said about simply swapping case and cut this and cut that but when you’ve just spent best part of £30 getting what you had been told before was the right part to get then your forgive me for being a bit reluctant to start cutting wires and swapping this for that also new to this site and this topic should have been posted in the diy installer forum not in here but thanks all for advice and assistance Quote Link to comment Share on other sites More sharing options...
al-yeti Posted October 26, 2019 Share Posted October 26, 2019 (edited) 2 hours ago, Andy cb said: Al-yeti I know what others have said about simply swapping case and cut this and cut that but when you’ve just spent best part of £30 getting what you had been told before was the right part to get then your forgive me for being a bit reluctant to start cutting wires and swapping this for that also new to this site and this topic should have been posted in the diy installer forum not in here but thanks all for advice and assistance So sounder was £30? Didn't realise you paid so much thinking it was speaker Apologies , yes hope you kept packaging return won't cost you more than a fiver and probably cost you £17 .50 in end for speak not to bad in the end Edited October 26, 2019 by al-yeti Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.