Hello, I'm sure it is possible but am struggling to find out how to do it. 

I would like the bellbox to display a form of flashing LED when armed.  I would be grateful for any support or guidance with this.

Thank you

EN50131 says there should be no visible indication to show that an alarm system is armed, so I would think it highly unlikely that it is in the programming of any system, even Pyronix 

The comfort LEDS are either enabled or disabled and that’s it. There is no input to trigger them. The status is determined by a link on the siren pcb.

Are you looking for the strobe to give you conformation of setting /unset coopers panels can give you a 3 strobe flash on both so might be in setting progg

19 hours ago, Gav1978 said:

Hello, I'm sure it is possible but am struggling to find out how to do it. 

I would like the bellbox to display a form of flashing LED when armed.  I would be grateful for any support or guidance with this.

Thank you

Or your basically using a wireless bellbox and it has no flashing LEDs in general 

 

Only option is to put in a wired bell

40 minutes ago, al-yeti said:

Or your basically using a wireless bellbox and it has no flashing LEDs in general 

 

Only option is to put in a wired bell

 

The Pyronix wireless bell box has the option to enable/disable ‘comfort’ flashing LED’s.

1 hour ago, Amps said:

 

The Pyronix wireless bell box has the option to enable/disable ‘comfort’ flashing LED’s.

Battery's last long? 

1 hour ago, al-yeti said:

Battery's last long? 

 

Dunno. 

46 minutes ago, Amps said:

 

Dunno. 

Ah ok, was going to compare with hkc, they have additional battery pack gives you 24-36 months approx depending on flash rate , otherwise single normal pack will give you 6months