Good Day to you Gents,

In a bid to save money, I decided to repair my home alarm system and replace the exterior bell sounder. Having done a bit of research, I wired the new Honeywell AG6 Bell system up as indicated in the picture attached,  however I am now unable to set the alarm as the 350 Panel LED indicates "tamper".  Could any of you please you have a look at the wiring to see where I have gone wrong and offer any advice?  I have attached a picture of the old bell box wiring setup which I took prior to removal. On the AG6 bell I have not wired in the white

New Honeywell AG6 Wiring

Yellow   TR-

Green   S-

Red        V+

Black      V-

Blue       ST-

White    Not Connected

 

Old Bell system Wiring  

Yellow   12V-

Green   F TMP Feed

Red        12V+

Black      S- Bell SW-

Blue       Strobe -

White    Strobe +

 

You need to show a pic of how its wired into the panel along with the new bell, the old bell wiring is irrelevant 

original bell would have never work correctly (tamper return)

 

new is wired in different colours to the old bell

 

 advice ? wire it up to match the controls....

 your new bell is incorrectly wired, try again, its to do with the green, black and yellow i believe, and don't forget your ear plugs