Good Day to you Gents,
In a bid to save money, I decided to repair my home alarm system and replace the exterior bell sounder. Having done a bit of research, I wired the new Honeywell AG6 Bell system up as indicated in the picture attached, however I am now unable to set the alarm as the 350 Panel LED indicates "tamper". Could any of you please you have a look at the wiring to see where I have gone wrong and offer any advice? I have attached a picture of the old bell box wiring setup which I took prior to removal. On the AG6 bell I have not wired in the white
New Honeywell AG6 Wiring
Yellow TR-
Green S-
Red V+
Black V-
Blue ST-
White Not Connected
Old Bell system Wiring
Yellow 12V-
Green F TMP Feed
Red 12V+
Black S- Bell SW-
Blue Strobe -
White Strobe +