Imnotshankled

If anyone has the manuals for this please let me know

You didn't do that already?

If you ordered it from contact orisec and they will send you a shipping label and a replacement for free and tbh if you are using the in panel receiver don't expect more than 5m range without a external antenna

Are you using eBay sorced stuff or direct from orisec

I made a total profit of £145 this year

Early 1996 veritas panels have no NVM protection The part set exit and entry tone is supposed to be a clicking tone and you only get a beep at the last 10 seconds

If not you can add a buzzer in the panel if it has a on board keypad

This can't be changed or altered unless you set the time to 10 seconds or less

The entry tone will be clicking until the last 10 seconds when you get a audible beep This can't be changed unless the entry timer is set to 10 seconds

Yes however you would get a different response

Unfortunately you can't if you have a tag to let you in engineer I can give you a COTD code the only option is to default and start fresh

Yes yes this can be programmed in using the keypad

Have you set COTD to on

They are not eurosec is a Risco product along with other horrible products pyronix are a separate company and are not related

You can set that zone to 13 day alarm and then go to volume control and set day alarm volume to 0 If you want it as a silent HU input set zone to 4

OI i was the one who mentioned it first

This is nothing compared to a premier shop I did recently system was a texecom Premier elite 48 Psu was on a plug Top and panel was wired into a 40a cooker feed with no fcu or earth Bell box had no battery in it All detectors except front door were disabled 2 PA buttons never wired in And Last but not least it had some crappy gsm SD

Never worked with companies on new builds eh

OK you have a texecom veritas r8 Looking at the wiring none of the zones are linked out and there's nothing wired to the SW out terminal which is good This most likely narrows the fault down th the pir the eol link on captures are a switch set it to OC OC which is the top option

Have you tried fitting the old PIR temporarily and testing that Are all the other PIRs working ok What panel do you have Is it a veritas as it could be wired to a switched output and or the zone linked out

Have you removed the EOLR links

Panel has a low or flat battery or mains has failed