Dose any one know where i can get decent exit terminators from all i can find is standard door bell pushes.

paxton access have a smart range

not to badly priced either

regards

glen

Elmdene & Knights Plastics do them as well. Although the ones we used at the big National before I left them from Knights were good in thought but utter rubbish. The amount of call outs we had to replace the rubber covers or pcbs etc was high.

Gardiner Security does the Arni Exit Terminator which is probably the best out of them all.

Edited August 28, 200520 yr by Selsport69

We use the arnie, no problems with any fitted

And if you need a surface-mount, rather than a flush mount (Like the ARNie), then Gardiners do one which does not look like a bell! (Can't remember what its called, but their technical sales will help.)

Gardiner Security does the Arni Exit Terminator which is probably the best out of them all.

66089[/snapback]

ARN1E = expensive but very nice! cost about the same price as a reasonable passive

Chris, if you are feeling like custom building one, maplins have some great vandal resistant buttons, some of which have LED's in them (don't power the LED's from the intruder psu as a burglar may short the power and disable the alarm panel!)

TSS

And if you need a surface-mount, rather than a flush mount (Like the ARNie), then Gardiners do one which does not look like a bell!  (Can't remember what its called, but their technical sales will help.)

66145[/snapback]

Dantec, Dantec, Dantec, Dantech

Jef

Dantec, Dantec, Dantec, Dantech

Jef

66282[/snapback]

This is available in three sizes to suit the application and has 2 colours of bezel included, with other colours available for registered installers.

You can play with a 3d visual model here (You have to accept the install of the 3D plug in if you don't have it installed already)

This is available in three sizes to suit the application and has 2 colours of bezel included, with other colours available for registered installers.

You can play with a 3d visual model here (You have to accept the install of the 3D plug in if you don't have it installed already)

66550[/snapback]

Drew i think you have gone off at a tangent. exit terminator is not a request to exit!

Jef