Where did Gardtec come from..?

Is there any writing on the panel or its pcb.

Where did Gardtec  come from..?

43919[/snapback]

Just looked like a Gardtec, hence the ? after it. Could be wrong though, it was a bit of a guess.

Panel's a XPC though is it not, or shall I just go away now?

its an accord xpc bellbox

Its a flashguard sounder (Xtravert)

http://www.klaxonsignals.com/security_sounders_value.htm

Where did Gardtec come from..?

Hi to all,

Dave is right that's no Gardtec bellbox, & panel isn't Gardtec either!!! Umm someone got the beer goggles on obviously, or is it back to the electrical vs alarms again!!!! As for the poor guy having a go himself, follow the wiring that the others have given you. Failing that faulty bell probably!!

all

on the main alarm panel there is

PCBC FR4A

thats all i can see apart from a load of numbers

So then to sum up:

the top trigger is trigger + LEAVE UNUSED

the next one down is trigger - GOES TO YOUR "?"

supply + GOES TO BELL +12V

supply - GOES TO 0V

strobe + LEAVE UNUSED

strobe - GOES TO PANEL STROBE

tamper + LEAVE UNUSED

tamper - GOES TO YOUR "T"

hi guys ive tried this out and it just keeps going off wont stop my keypad wont stop it either, any other suggestions

the top trigger is trigger + LEAVE UNUSED

the next one down is trigger - GOES TO YOUR "?"

supply + GOES TO BELL +12V

supply - GOES TO 0V

strobe + LEAVE UNUSED

strobe - GOES TO PANEL STROBE

tamper R LEAVE UNUSED

tamper S GOES TO YOUR "T"

are the last 2 correct

Edited March 14, 200521 yr by neo

I would have tried Tamper R to "T" and not "S"?

Hmm, he did say Tamper + & - on previous post.. But yeah agreed now.

tamper R LEAVE UNUSED

tamper S GOES TO YOUR "T"

But perhaps Tamper S = Tamper supply, in which case it needs a link from 0v

And yeah Tamper R to your "T".