2 hours ago, MrHappy said:

I'd assume the spark may have tested a new spur with your controls attached

 

I have spare psu's, I did have issues some years ago, they go funny before failing...

 

 

The logs show 1 mains fail & loads of tampers & supervision faults ?

 

Is the sub seeing unreset faults when they put their code in for another tamper or supervision fault? 

 

 

What's the max time I can set for the AC Delay?

21 minutes ago, Hugh94 said:

What's the max time I can set for the AC Delay?

 

250 minutes ?

2 hours ago, Hugh94 said:

1, goes from a spur to a built in step down/PSU to 13-15v, checked voltage on it and gives out correct voltage

What about current draw? As Happy mentions are the devices (inc bells) connected wireless

3 hours ago, PeterJames said:

What about current draw? As Happy mentions are the devices (inc bells) connected wireless

 

3 hours ago, PeterJames said:

What about current draw? As Happy mentions are the devices (inc bells) connected wireless

Here's what the panel sees, I still need to find the time to get out and check the supply myself again after the new spur has been installed

8 hours ago, MrHappy said:

I'd assume the spark may have tested a new spur with your controls attached

 

I have spare psu's, I did have issues some years ago, they go funny before failing...

 

 

The logs show 1 mains fail & loads of tampers & supervision faults ?

 

Is the sub seeing unreset faults when they put their code in for another tamper or supervision fault? 

 

 

So supervision faults pop up here and there like the bell and the farthest away pir but then clear again, I changed the timer to 250 and reset but still not staying clear, the current is 0.0A, see picture attached for details 

Hugh, 

 

I'm going with 1 x Plaggy enforcer controls & NOTHING as wired devices on the system  ?

 

Supervision fault, what's the signal strength of each radio device on the system ?

 

Are all batteries 2yrs old or less, when they are replace spin them around in the holder to ensure there are go contacts

 

If the house is not 'kin massive & the controls are no in silly place eg in cupboard surrounded by display cases of lead painted figures or something 

 

Swap the device far away for an identical item which works fine in a different location, ideally the item which drops of in location A should drop on in location B, proving the device is duff... chances are all the hardware is fine & its an issue with the environment of the installation ?