Brian Cork Posted May 10, 2021 Share Posted May 10, 2021 Hi All, Any suggestions appreciated! I have a problem with a C-Tec, 2 Zone panel which keeps triggering the "General Fault" and "Power Supply Fault" beep. There is only one Zone with 5 detectors. The mains trip switch has been replaced, and the mains supply feeds a second panel, which does not have any problem. The panel and backup batteries have been replaced. There are no Zone Fault Alarm, and the detector are triggering when tested. Any ideas what might be causing the problem ? Link to comment https://www.thesecurityinstaller.co.uk/community/topic/44554-c-tec-2-zone-panel-with-intermittent-general-fault-alarm/ Share on other sites More sharing options...
PeterJames Posted May 10, 2021 Share Posted May 10, 2021 You could try replacing the PSU but in my experience this rarely fixes it its normally the panel buggered down to the batteries not being replaced frequently enough Link to comment https://www.thesecurityinstaller.co.uk/community/topic/44554-c-tec-2-zone-panel-with-intermittent-general-fault-alarm/#findComment-510677 Share on other sites More sharing options...
sixwheeledbeast Posted May 10, 2021 Share Posted May 10, 2021 Had the occasional one where a power cycle makes it go away. Have you checked everything over with a meter? You replaced the whole panel then? Link to comment https://www.thesecurityinstaller.co.uk/community/topic/44554-c-tec-2-zone-panel-with-intermittent-general-fault-alarm/#findComment-510678 Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now