More expense! Might do it when I get paid.

43 minutes ago, Cyberprog said:

More expense! Might do it when I get paid.

V7 was bugged proper by the way hopefully you updated revision

The 520 was just updated to 7.02. I guess that's the same F/W across the board.

3 hours ago, Cyberprog said:

The 520 was just updated to 7.02. I guess that's the same F/W across the board.

It will do , although it 7.03 for a bit now , you get it free?

Might have been 7.03 - yep, well, beer tokens. The chap who runs selfmon sent us a SPI key with it on there as his 520 had some stupid ADT firmware without any fire zone type.

 

If I did more of this I'd invest in the programmer and an SPI key of my own, but it's just my alarm here at home, the workshop and my mates place I look after now! Used to do way more but stopped being self employed 4 years ago and passed all the others off to other companies.

Hello, I know this is a really old thread but Honeywell tec are not helpful on this, is it possible to use the TCC800M or the TCPA2B 'fobs' to trigger a zone, there is mention of this in the RF Rio manual and the Galaxy Dimension manual says refer to the installation manual but we have an RF Portal and I cannot find a similar installation manual for the portal anywhere (no 'programming' manual with the portal either).  The only option seems to be to add the RF fob to a user but that generates a duress and I don't want that, I want to use a button as a link source, can this be done?

 

Thanks in advance

 

can be done on the old radio rio, doubt it can on the portal.

40 minutes ago, james.wilson said:

can be done on the old radio rio, doubt it can on the portal.

Not linking the zone?

dont think you can set the button as a circuit like you could on the radio rio

49 minutes ago, Armadilloshield said:

Hello, I know this is a really old thread but Honeywell tec are not helpful on this, is it possible to use the TCC800M or the TCPA2B 'fobs' to trigger a zone, there is mention of this in the RF Rio manual and the Galaxy Dimension manual says refer to the installation manual but we have an RF Portal and I cannot find a similar installation manual for the portal anywhere (no 'programming' manual with the portal either).  The only option seems to be to add the RF fob to a user but that generates a duress and I don't want that, I want to use a button as a link source, can this be done?

 

Thanks in advance

 

What's the end result your trying to achieve? Let zone know when kettle is boiled? Just joking 

 

What you want to do with it