Skip to content
View in the app

A better way to browse. Learn more.
Security Installer Community

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Viper Wiring to Texecom Panel

Al H
in Members Lounge (Public)

Featured Replies

Good morning all

 

Advise please. Wiring a Viper GLX shock sensor 8 wire to a Texecom Premier Elite 24. I am using EOL wiring in the zones. I assume I wire in the 4K7 & 2k2 resistors as I have on PIR’s.

 

However Terminal 7 the set input to remotely control the LED and terminal 8 first to alarm. How should I wire these and were do I connect on the panel? There is also a resistor that comes with the Viper, what about this?

 

Thank you

 

 

 

 

2B834C18-50D3-4F52-9A26-1AF88DA04FD3.jpeg

fta and set are only needed if connecting more than 1 device per circuit. the set connects to an output programmed as that and fta links the vipers together as per the manual

securitywarehouse Security Supplies from Security Warehouse

Trade Members please contact us for your TSI vetted trade discount.

I personally still connect the set even if you only use one, it's good to see if the device has been activated even if unset.

As above FTA is a stand alone bus that doesn't go back to the controls.

You will likely need to invert any outputs as PE24 only has -ve sinking.

 

  • Author

Thanks JW & 6WB

 

Ok so If i connect a wire into the SET and ignore the FTA. Where would i connect the SET lead into the panel?

 

 

into one of the outputs

securitywarehouse Security Supplies from Security Warehouse

Trade Members please contact us for your TSI vetted trade discount.

Digi Output 7 is most likely already setup for your needs, you may just have to invert it in the output menu.

Create an account or sign in to comment
Go to topic listing

Recently Browsing 0

  • No registered users viewing this page.

Important Information

By using this site, you agree to our Terms of Use.

I accept

Account

Navigation

Search

Search

Configure browser push notifications
Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.