ElecTech Posted October 8, 2017 Share Posted October 8, 2017 I'v never done "service" as a job role nor does our company hold any intruder maintenance contracts... Can someone confirm the steps to what's required as a bare minimum when doing a PPM. Im thinking... Walk test every device Sample test some tampers depending on the size of install Sample test resistance on devices again depending on the size of install Battery calcs (batt volt, current in alarm, current in standby, batt charging volt) all signals to ARC inc comms fail both paths? Set/unset where possible Bell test, test bell tamp, remove power Check no rearms, entry timers, exit timers, bell duration, reset levels Compare as fitted install to specification Fill out maintenance log... I'm unsure so add, correct or remove anything to help... Quote Link to comment Share on other sites More sharing options...
al-yeti Posted October 8, 2017 Share Posted October 8, 2017 15 minutes ago, ElecTech said: I'v never done "service" as a job role nor does our company hold any intruder maintenance contracts... Can someone confirm the steps to what's required as a bare minimum when doing a PPM. Im thinking... Walk test every device Sample test some tampers depending on the size of install Sample test resistance on devices again depending on the size of install Battery calcs (batt volt, current in alarm, current in standby, batt charging volt) all signals to ARC inc comms fail both paths? Set/unset where possible Bell test, test bell tamp, remove power Check no rearms, entry timers, exit timers, bell duration, reset levels Compare as fitted install to specification Fill out maintenance log... I'm unsure so add, correct or remove anything to help... Hmmm looking at records from time to time , a third of that list is charged about £60 , and not allot of that is done Quote Link to comment Share on other sites More sharing options...
Amps Posted October 8, 2017 Share Posted October 8, 2017 (edited) 1 hour ago, ElecTech said: I'v never done "service" as a job role nor does our company hold any intruder maintenance contracts... Can someone confirm the steps to what's required as a bare minimum when doing a PPM. Im thinking... Walk test every device Sample test some tampers depending on the size of install - will cause more problems than it solves. Sample test resistance on devices again depending on the size of install Battery calcs (batt volt, current in alarm, current in standby, batt charging volt) all signals to ARC inc comms fail both paths? - don't touch that Dualcom Ariel it will eventually break! Set/unset where possible Bell test, test bell tamp, remove power - test bell tamp will cause more problems than it solves. in a perfect world it should be tested though Check no rearms, entry timers, exit timers, bell duration, reset levels Compare as fitted install to specification Fill out maintenance log... I'm unsure so add, correct or remove anything to help... Edited October 8, 2017 by Amps Quote Link to comment Share on other sites More sharing options...
PSE Posted October 8, 2017 Share Posted October 8, 2017 (edited) Deleted Edited October 8, 2017 by PSE Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.