Hallo

 

Can everyone help me with Texecom Premier Elite 24 and LCDLP Blue Keypad.

 

I have just a flat and only one Door to secure.

 

It`s just one NC Contact on Zone 1 connected.

 

How shall I programming the device?

 

And sorry for my bad english.

 

Thank you Best Regards Daniel

 

 

 

Edited August 1, 20178 yr by Daniel G

Yes, you will need to make sure you programme the zone on the panel for Normally Closed.

Assuming this is the entry door it will need to be Entry/Exit type also.

ok.I do have this two settings.

What about Zone Atributes.

Do I need the them?

 

 

Most things should be fine OTB for a one zone job.

Test it and make sure it works.

Thank you very much!

 

I forgot the Confirm Device step.

 

We have a idiom in Germany: Everyone who can read have an advantage..

 

 

I have another Question

 

I connect the normally close contact without tamper now on the LCDP Zone 1

Zone Wiring Setting is: Normally Closed

The system don't recognize the contact.

In Menue View Zone Status also not.

How can I activate Zone 1 at the LCDP

Or is the wiring wrong?

 

 

you need to link out T and connect to just the A connections

Keypad zones have to be mapped. This is Keypad number 1 so Zone 1 on Keypad need mapping to a zone between 1-24.

You set the zone wiring type per zone as well.

You don't need to Link out T just make sure it's programmed as Normally Closed.

Thank you for you help!!!

The Keypad was not mapped. The system works fine now!

Have a nice evening!

Daniel