Jump to content
Security Installer Community

Scantronic 9448 Entry Problem


Recommended Posts

I have a Scantronic 9448 panel which has a PIR working on the entry/exit zone.

 

On exit the sounder bleeps intermittingly, to show the detector is working. However, on entry the sounder doesn't operate at all, therefore if I forget to turn the panel off, it goes in to full alarm on entering another room.

 

Please suggest solution to the problem

Link to comment
Share on other sites

Thank you for the replies, the system is an old system, which has worked fine.

 

The detector has been walk tested and shows an intermittent tone on exit, which is correct but don't t sound on entry.

 

The wiring has not been touched and has worked fine for two years, so its not a wiring fault.

 

Could a power failure alter the program?

 

I don't believe there is a setting which programs the sounder as silent on  exit/entry.

 

 

 

 

Link to comment
Share on other sites

Just to be clear, when you say it's been walk tested you mean on the panel, not just red light flashing on the PIR?

 

I'll be honest I am a bit stumped. As the panel is so basic I would prob. recommend a factory default and reprog.

So, I've decided to take my work back underground.... to stop it falling into the wrong hands

 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.