djrock Posted June 8, 2014 Share Posted June 8, 2014 Hello, I got a new/old stock 9651en for a friend, in the log around about the start there is a EEPROM fail then there are several other entries like tampers, pa zone open. Then there is entries that I know I have caused like system startup, lid tamper, engineer on site. Roughly where I started generating entries in the log there has not been another mention of EEPROM fail. Is it normal to have EEPROM fail at the very start of the log? Thankyou Djrock Quote Link to comment Share on other sites More sharing options...
al-yeti Posted June 8, 2014 Share Posted June 8, 2014 I have seen that on startup not sure why, but it shouldn't occur again once your setup and running, It may occur if you default the system aswell Quote Link to comment Share on other sites More sharing options...
datadiffusion Posted June 8, 2014 Share Posted June 8, 2014 Yes normal on this panel from factory BEFORE installation time(s) AFAIK. Quote So, I've decided to take my work back underground.... to stop it falling into the wrong hands Link to comment Share on other sites More sharing options...
djrock Posted June 9, 2014 Author Share Posted June 9, 2014 Hi, ok, that's good it's normal. Thankyou Djrock Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.