_2d2230.png)
_5a42ce.png)
Monty
Trade Full Member
-
Joined
-
Last visited
Everything posted by Monty
-
Use the out puts and progg to follow partition not sure how much current your sound one draws possible use smart relay just in case
-
Progg a bell delay long enough for you to carry out what you want to do then reset as normal ( remember to remove )
-
Would agree one to be replaced
-
We use Menvier dose drop out some times ( prob all do ) over all good site
-
Are you looking for the strobe to give you conformation of setting /unset coopers panels can give you a 3 strobe flash on both so might be in setting progg
-
Engineer on site means you have left engineer put in your code then ent ent 1
-
Take a look at the Ion 40 H good robust easy to use and secure app
-
Yes we did have a lot of keypads to replace then they withdrew the 'new ' keypad due to using batt to quick !! Only had 1/2 that did that but never recalled we still have them on the shelf but do we fit or will give us problems !!
-
We use the Eton kit ( Menvier )now badged Ion use 30 r and 40 H both have proven them selves ( most of the time ) also Memvier 40 with bolt on wireless all the same periphirels across the range and the new app for 30 and 40 is good and reliable worth a look at Tec back up not as good as used to be and never see a rep Allan M
-
We use the coopers M12 and fit remote sounders and an Expander PSU - along with Ion 40H remote access to sys tem with coms works very well and quick and easy to identifie fault/fire alarm not always so easy on the mains operated ones
-
Sounds like it's set up to lock the key pad out on entry will prob let you use a code to unset once entry timer has run out if this is the case just have to find the setting in DD243
-
the 1st panel we put in was a tunstall CPA6 in a school where we had the Electrical contract Quite a hard one to start on but made the next (A1 9000 ) easy
