_2d2230.png)
_5a42ce.png)
Vini
Member
-
Joined
-
Last visited
Everything posted by Vini
-
Ok; sorry folks! - Do I need to be in the panel/move any wiring? - 1001 thru 1004 seem to be pretty much essential...? Would changing these have a detrimental affect on the operation? I just need to nail this and im set...
-
So I can change 0001 from Fire to DetRst, but I'm not sure how link that specifically to what is Zone 1004 in this case... I am not entirely sure which Zone 1004 is in the panel... Do I even need to be in the panel!?!?
-
I've read the book of words and it's got me confused... My outputs; 1001 Set 1002 SPK Driver 1003 Bell 1004 Strobe 0001 Fire 0002 Panic 0003 Intruder 0004 Assist 0005 Omit 0006 Fault 0007 Confirm 0008 Tamper Is it simply a case of changing 0003 Intruder to DetRst? Would that change all my Zones set to Intruder to DetRst, and if so, is that a problem? I'm guessing I cannot set a specific zone to a specific output via RKP. Looking at the wiring within the panel, I am able to identify the Viper, however, cannot see how changing the wiring in there would help. Help?
-
The LED was off when closed/clear, after triggering the GLX during testing, the LED is constantly flashing.
-
Is that drop power to the GLX, or panel? Bit of a pain really - can I disable the LED totally, given its location it would be fairly obvious if that was the PoE?
-
Finally got round to sorting this tonight, during testing all was well. But since it has triggered, the LED has not stopped flashing. Arming/Disarming has not helped. Anyway to sort/reset this?
-
I'll look out for that. Thanks for the tip with the bare wires too. This is just hooked up temp so I know what goes where whilst the room is refurbed.
-
-
My hero It's a brand new Viper GLX, I don't understand the above, but am assuming I don't need to do anything funky?
-
Hey all, just in the process of rejigging the alarm, and it's been a while since I've tinkered with the wired stuff... I want to switch a single PIR for a Shock on my G2-20... Forgetting the 'quality' of the wiring, how would this transplant over to the Viper? And resister location?? Thanks in advance!