Search the Community
Showing results for tags 'g2-20'.
-
Hey all, just in the process of rejigging the alarm, and it's been a while since I've tinkered with the wired stuff... I want to switch a single PIR for a Shock on my G2-20... Forgetting the 'quality' of the wiring, how would this transplant over to the Viper? And resister location?? Thanks in advance!
-
Hi All Hope all is well. I hope this is not a stupid question. I thank you in advance. I've purchased a Honeywell galaxy ethernet module. I have a query in relation to powering down the panel prior to installing it. When i have put the panel into engineers mode, and disconnect the fused spur, i will have to remove the backup battery power also. Will the external bellbox sound, when the backup battery power is removed? Appreciate your reply. Great forum. Regards Zemme
-
Hi Folks Hope everyone is well. I am looking for a bit of advice. Any advice is appreciated. I currently have a standard honeywell door contact sensor on my front door and patio door. It is already wired up & working fine. I want to upgrade them to Viper GLX Shock Sensor With Contacts. Do i simply cable the new Viper exactly the same as the existing sensor? Or do i need to use extra wiring back to the panel? Thanks in advance - Enjoy the weekend. Regards Zemme
-
Hi All Hope you are all well. I hope i am posting my query on the correct thread. I would dearly appreciate any advice that is provided for my query. I recently had a Honeywell Galaxy G2-20 installed by my uncle. He has only installed a couple of these Honeywell alarms previously, however he is stumped on a certain issue. My setup is as below. 1 X Honeywell Keyprox MK7 CP-038 Keypad (Address 0, Downstairs) 1 X Honeywell Keyprox MK7 CP-038 Keypad (Address 1, Downstairs) 1 x Honeywell RF Portal (Address 4) The issue that i currently face is that the only functioning keypad is downstairs