petercts

Is the sounder on with more than one screw or fixed with cable clips if so its a proper job or maybe no more nails and the local cable rules state staple guns and washing lines are also up to the standard of an approved installer

hi Texecom looks for 2k2 across two cores end of line with 4k7 as a shunt across the alarm relay only as a single eol

hi is it still set to grade 3! if so you only need grade 2 this is a great system but is not intended as a easy diy fit it is aimed at high security and a police response.

hi if the panel is programed to bells and sounder on confirmed this is used on commercial or large domestic systems mainly on a police response system confirmed alarms need two detectors to activate in one area to generate an audible alarm an example is one detector in a shop by the front door and a 360 disc in the same area if one activates the alarm send an unconfirmed signal if both see movement then the bells ring and it sends a confirmed alarm if you have only one detector in a room and you want an audible alarm you need to change the option in wintex under system config to bell 1st alarm and sounder 1st alram hope this helps peter

hi have used powerline adapter to network dvr back from out buildings and down from the loft on many jobs use tp link 300 or 500 mps models find they work 99.9 % of the time without a problem, if they lock up you need to reset the mains .the cheap ones off ebay rated at 100mps fail after a few months, also the one that you can still put a 13 amp plug in also cause problems i have found they all require a good earth and work well over 100m if on the same fuse board also used in offices with covert camera installs

hi the problem is menvier used the node box for ever thing for many years from a six zone expander to radio node to x node or m node and if the panel box is full size they used that for years to