Jump to content
fireyfox

Texecom elite flasher woes

Recommended Posts

Hi

I'm hoping someone my have seen this before and could share some knowledge.

I have an Elite 88, I would like to upgrade the firmware. Whenever the flasher cable is plugged into the programming port, both the heartbeat and Txt/Rxt leds do not illuminate on power up. The cable is plugged up correctly I believe, the red ident matching the arrow bottom left of the 10 pin header. Ribbon cable not faulty as no problems when connected without flasher pcb attached. 

This is where you say it's normal don't worry and get flashing! I've tried flashing and the software responds board failed to respond correctly.

With the flasher cable removed, on power up heartbeat and tx/rx respond as expected.

 

Any ideas?

 

Share this post


Link to post
Share on other sites

Have you tried ringing texecom technical?

 

(not being funny) but would recommend as they are very helpful (when you eventually get through)

Share this post


Link to post
Share on other sites
1 hour ago, aissecur said:

Have you tried ringing texecom technical?

 

(not being funny) but would recommend as they are very helpful (when you eventually get through)

Are they that busy with DIY?

 

Hkc I guess smaller odd time they have been busy you get put on a call back list. And they always call 

Edited by al-yeti

Share this post


Link to post
Share on other sites
On 09/02/2018 at 22:03, fireyfox said:

This is where you say it's normal don't worry

 

It is.

 

On 09/02/2018 at 22:03, fireyfox said:

 I've tried flashing and the software responds board failed to respond correctly.

 

So there maybe an issue with the flasher, Com lead or PC drivers.

Also you need to start with the switch on Run before you plug everything together.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Recently Browsing   0 members

    No registered users viewing this page.

×