Hi,

 

I’ve got a Veritas R8 Panel that I have tapped in to a couple of the communicator outputs to identify through a home automation system whether the panel is armed or whether the alarm has been triggered. 

 

Is there a way I can identify if the panel has been  part set vs full set through any of the communicator outputs ?

 

 

I doubt a basic panel like the veritas can but there maybe a programmable output. On the better panels you can

5 minutes ago, james.wilson said:

I doubt a basic panel like the veritas

 

r8+ has 8 channels, line monitor & remote reset

 

 

 

Just now, MrHappy said:

 

r8+ has 8 channels, line monitor & remote reset

 

 

 

programable channels?

Just now, james.wilson said:

programable channels?

 

fixed (irrc) anticode reset too.

 

 

It’s the R8+ I have

 

Sadly the engineer code isn’t known and it’s been changed from the default. I’m reluctant to reset the panel in case the engineer code has been locked.. but I’ve been able to use the communicator outputs for the basics of what I need... 

 

What does the line monitor output provide ?

Edited August 14, 20196 yr by DanEdge

7 minutes ago, james.wilson said:

programable channels?

 

no, we did have some on 8440's or those csl digi's

 

 

there really was'nt much n the way of space or current...

12 minutes ago, DanEdge said:

What does the line monitor output provide ?

 

input, removes bell delay when there's a telephone line fault

Thanks. What does the zone lockout provide?

2 minutes ago, DanEdge said:

Thanks. What does the zone lockout provide?

zone omit notification to the arc