Firmware probably doesnt match as I found out recently trying to add an expander to an Ion 160, contact Eaton Tech support desk for confirmation.

 

Thanks for the reply’s everyone, appreciated 

 

ian would this be still the case as I have the new contact workings fitted on zone 1, it was mainly to rule out a faulty contact. 

 

But still cant add in a 9th zone, that now being the old original contact. 

 

One minute I can’t clear the Tamper then when I delete it and re-learn it the fault will change to the door showing open and not walk testing, it’s strange when the Tamper fault exists it walk tests fine, the next time after I re-learn it will tell me zone is open and not seeing any Tamper.

 

Bizarre, also Eaton won’t talk to me as I’m not a company and just doing it diy. 

Edited May 26, 20187 yr by Rabmcnaught

On 26/05/2018 at 23:04, Rabmcnaught said:

Thanks for the reply’s everyone, appreciated 

 

ian would this be still the case as I have the new contact workings fitted on zone 1, it was mainly to rule out a faulty contact. 

 

But still cant add in a 9th zone, that now being the old original contact. 

 

One minute I can’t clear the Tamper then when I delete it and re-learn it the fault will change to the door showing open and not walk testing, it’s strange when the Tamper fault exists it walk tests fine, the next time after I re-learn it will tell me zone is open and not seeing any Tamper.

 

Bizarre, also Eaton won’t talk to me as I’m not a company and just doing it diy. 

Pm sent

On 26/05/2018 at 23:04, Rabmcnaught said:

Bizarre, also Eaton won’t talk to me as I’m not a company and just doing it diy. 

Good to see that there are stll a few manufactures still keep information 'in house'