Staniel Posted September 3, 2017 Share Posted September 3, 2017 I've just moved into a new house which has an i-on16 system installed, the keypads are reporting that the control panel is open and I have been unable to find any documentation that shows you how to reset this. Any help will be greatly appreciated! Quote Link to comment Share on other sites More sharing options...
al-yeti Posted September 3, 2017 Share Posted September 3, 2017 Is it open? Quote Link to comment Share on other sites More sharing options...
datadiffusion Posted September 3, 2017 Share Posted September 3, 2017 (edited) It is very easy to close these lids up without the tamper being closed, esp. if the original screws have been lost.  I don't fit the 16 myself but the plastic case on the 40 / 40H / 30R is identical.  Or just as easy, as the tamper switch plugs in via a molex (minature plug) for an engineer in a hurry to leave it off.  As Al, have a look at the main unit and let us know... Edited September 3, 2017 by datadiffusion Quote So, I've decided to take my work back underground.... to stop it falling into the wrong hands  Link to comment Share on other sites More sharing options...
Staniel Posted September 3, 2017 Author Share Posted September 3, 2017 The panel on the control box is fully closed. Is there a way to open the control panel without setting the alarm off to check? Quote Link to comment Share on other sites More sharing options...
al-yeti Posted September 3, 2017 Share Posted September 3, 2017 33 minutes ago, Staniel said: The panel on the control box is fully closed. Is there a way to open the control panel without setting the alarm off to check? If you have user code then shouldn't matter because panel is already reporting it's open ? Quote Link to comment Share on other sites More sharing options...
Amps Posted September 3, 2017 Share Posted September 3, 2017 If I remember right "system tampers" are defaulted as engineer reset. You will need the engineers code to reset the system tamper. Quote Link to comment Share on other sites More sharing options...
al-yeti Posted September 3, 2017 Share Posted September 3, 2017 4 hours ago, Amps said: If I remember right "system tampers" are defaulted as engineer reset. You will need the engineers code to reset the system tamper. Is reporting open same as reset needed , thought message goes but red light stays in until reset Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.