rsrfire Posted September 10, 2014 Share Posted September 10, 2014 I have a problem in that I have changed a broken cover which was not allowing the system to be set as it was showing tamper inactive fault, after swapping cover the message remains the same, any suggestions? Quote Link to comment Share on other sites More sharing options...
datadiffusion Posted September 10, 2014 Share Posted September 10, 2014 Was the fault Bell Tamper or Global Tamper? Or is the system set for EOL? Quote So, I've decided to take my work back underground.... to stop it falling into the wrong hands Link to comment Share on other sites More sharing options...
norman Posted September 10, 2014 Share Posted September 10, 2014 Have you tried to reset the panel, also does the sounder have a back tamper Quote Nothing is foolproof to a sufficiently talented fool. Link to comment Share on other sites More sharing options...
antinode Posted September 10, 2014 Share Posted September 10, 2014 May need an engineer reset. I know the 9651 requires an eng reset on certain conditions of which a bell tamper may be one. Quote Trade Member Link to comment Share on other sites More sharing options...
Alarm Protection Posted September 10, 2014 Share Posted September 10, 2014 The cover on the bellbox was broken? Quote ! Link to comment Share on other sites More sharing options...
datadiffusion Posted September 10, 2014 Share Posted September 10, 2014 As above may need an eng reset, that's an option for sure, but also the message won't just clear by itself. You'll need to enter your user code and acknowledge the fault, IF its user reset it should then reset IF the fault is clear. Quote So, I've decided to take my work back underground.... to stop it falling into the wrong hands Link to comment Share on other sites More sharing options...
rsrfire Posted September 11, 2014 Author Share Posted September 11, 2014 yes the bell is only about 8ft of ground level and 4ft from a main road, which was recently resurfaced , I`m assuming that a debris was thrown up and took out about a 3inch hole Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.