Jump to content
Security Installer Community

What Detector Or Device To Put On Automatic Glass Sliding Door


Recommended Posts

When i glued them maglocks i put si much attention into covering my ass, i had not thought about of the look from the other side through the glass.

Decided not so pretty showing all this glue, had a good look round local B&Q could not find any finger panels. Searching for insperation, i spotted and covered with a couple of aluminium vent plates instead - and charged £50 more :).

If you think education is difficult, try being stupid!!!!

Link to comment
Share on other sites

For the quote.

Add made to measure for the closer and locks in situ, same tint if used. Ect Ect

Why i was so hyper, imagine sticking successfully then to find they were pizzed!

To be safe I clamped a sprit level using quick cramps, then butted the brackets to it, again quick cramped. Although fast setting adhesive (cost iirc £35.00 for a really small amount), i kept them held fast while hot on doing the rest of the works.

Final test was to literally hang off the bracket using a strap, that must have been a site on its own for the managers watching!

If you think education is difficult, try being stupid!!!!

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.