EdBrimley Posted July 4, 2012 Share Posted July 4, 2012 I recently removed a DT from the wall to run some cabling behind it. It went into tamper as expected when the cover was removed and my user code silenced system. I now don't seem to be able to clear the tamper fault having remounted on wall and replaced cover. I have engineer code but cannot find how to reset. Any ideas? Link to comment https://www.thesecurityinstaller.co.uk/community/topic/33114-texecom-premier-zone-tamper-reset/ Share on other sites More sharing options...
james.wilson Posted July 4, 2012 Share Posted July 4, 2012 I would guess you havnt seated the tamer and or lid correctly securitywarehouse Security Supplies from Security Warehouse Trade Members please contact us for your TSI vetted trade discount. Link to comment https://www.thesecurityinstaller.co.uk/community/topic/33114-texecom-premier-zone-tamper-reset/#findComment-285513 Share on other sites More sharing options...
EdBrimley Posted July 4, 2012 Author Share Posted July 4, 2012 Should it clear itself then or would I need to Confirm Devices? Link to comment https://www.thesecurityinstaller.co.uk/community/topic/33114-texecom-premier-zone-tamper-reset/#findComment-285551 Share on other sites More sharing options...
james.wilson Posted July 4, 2012 Share Posted July 4, 2012 it wont clear itself but if you make sure the tamper is closed then it should reset securitywarehouse Security Supplies from Security Warehouse Trade Members please contact us for your TSI vetted trade discount. Link to comment https://www.thesecurityinstaller.co.uk/community/topic/33114-texecom-premier-zone-tamper-reset/#findComment-285552 Share on other sites More sharing options...
EdBrimley Posted July 4, 2012 Author Share Posted July 4, 2012 where do i find the reset command in the menu. I have searched all manuals and cannot find it? Link to comment https://www.thesecurityinstaller.co.uk/community/topic/33114-texecom-premier-zone-tamper-reset/#findComment-285555 Share on other sites More sharing options...
james.wilson Posted July 4, 2012 Share Posted July 4, 2012 Look at reseting after an alarm. Entering your code should so it. But entering and exiting engineer mode definetly will securitywarehouse Security Supplies from Security Warehouse Trade Members please contact us for your TSI vetted trade discount. Link to comment https://www.thesecurityinstaller.co.uk/community/topic/33114-texecom-premier-zone-tamper-reset/#findComment-285556 Share on other sites More sharing options...
EdBrimley Posted July 4, 2012 Author Share Posted July 4, 2012 Great! I'll give it a go thiis weekend. Thanks for ther advice. Much appreciated Link to comment https://www.thesecurityinstaller.co.uk/community/topic/33114-texecom-premier-zone-tamper-reset/#findComment-285557 Share on other sites More sharing options...
sixwheeledbeast Posted July 4, 2012 Share Posted July 4, 2012 To user reset on a Premier enter your code twice then press reset. If on Tamper Engineer reset it will require and engineers reset. Link to comment https://www.thesecurityinstaller.co.uk/community/topic/33114-texecom-premier-zone-tamper-reset/#findComment-285588 Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.