J&D Security

Did you check the back tamper was closed, if he fitted the back plate upside down then the back tamper would never work unless the sensor was also fitted upside down.

You've asked for two things which are against the forums rules. No defaulting info, or codes

Hello

I'd say they use a lot of Inner Range kit for intruder and access control, it's an Australian product, I've used it a couple of times in the UK.

Have you got tones switched on on the Dialler on the phone, the SD1 needs either pulse dialling or short duration tones. Also the 8 button should be pressed for about 1 second.

http://www.electronics-tutorials.ws/electromagnetism/hall-effect.html

Hello

The static IP address for your device will be a local network address, just pick one in range and enter it in the dvr then forward the ports to this address. Your static IP from your ISP will be the address that the APP/Software uses to gain access from outside your local network.

You need to use your public IP address and set up port forwarding on you router, just google your router and port forwarding and make sure you use the public IP address not you local IP address.

You'll also need your public IP address not your Local IP address. Your public IP address should also be static which you can buy from you internet provider.

Hi

How are you checking the alignment. The beams I've used before either had led indicators or you had to use a volt meter to measure an output and get the output into a certain range, different led's or voltages meant different alignment strength. There must be a method to check with this type of beam, perhaps they aren't aligned correctly.

As sixwheeledbeast said I doubt you'll find anyone on here that has used/knows the product. I would try them in close proximity to the panel/reciever to make sure it not a weak transmission signal. Set them up temporarily and test them.

Welcome to London where the roads belong to cyclists and pedestrians and motorists are a second thought. Only in london are pedestrians on walk for 3 minutes and cars on go for 3 seconds

Thanks again. There's no alarm monitoring just remote client access with the mobile app. So over all a good product and worth the money. Thanks for you advice

Thanks

Hi, I was after peoples opinions on HikVision's HDTVI range of cameras and DVRs Thanks