Daniel G Posted August 1, 2017 Share Posted August 1, 2017 (edited) Hallo Can everyone help me with Texecom Premier Elite 24 and LCDLP Blue Keypad. I have just a flat and only one Door to secure. It`s just one NC Contact on Zone 1 connected. How shall I programming the device? And sorry for my bad english. Thank you Best Regards Daniel Edited August 1, 2017 by Daniel G Quote Link to comment Share on other sites More sharing options...
sixwheeledbeast Posted August 1, 2017 Share Posted August 1, 2017 Yes, you will need to make sure you programme the zone on the panel for Normally Closed. Assuming this is the entry door it will need to be Entry/Exit type also. Quote Link to comment Share on other sites More sharing options...
Daniel G Posted August 1, 2017 Author Share Posted August 1, 2017 ok.I do have this two settings. What about Zone Atributes. Do I need the them? Quote Link to comment Share on other sites More sharing options...
sixwheeledbeast Posted August 1, 2017 Share Posted August 1, 2017 Most things should be fine OTB for a one zone job. Test it and make sure it works. Quote Link to comment Share on other sites More sharing options...
Daniel G Posted August 2, 2017 Author Share Posted August 2, 2017 Thank you very much! I forgot the Confirm Device step. We have a idiom in Germany: Everyone who can read have an advantage.. Quote Link to comment Share on other sites More sharing options...
Daniel G Posted August 2, 2017 Author Share Posted August 2, 2017 I have another Question I connect the normally close contact without tamper now on the LCDP Zone 1 Zone Wiring Setting is: Normally Closed The system don't recognize the contact. In Menue View Zone Status also not. How can I activate Zone 1 at the LCDP Or is the wiring wrong? Quote Link to comment Share on other sites More sharing options...
james.wilson Posted August 2, 2017 Share Posted August 2, 2017 you need to link out T and connect to just the A connections Quote securitywarehouse Security Supplies from Security Warehouse Trade Members please contact us for your TSI vetted trade discount. Link to comment Share on other sites More sharing options...
sixwheeledbeast Posted August 2, 2017 Share Posted August 2, 2017 Keypad zones have to be mapped. This is Keypad number 1 so Zone 1 on Keypad need mapping to a zone between 1-24. You set the zone wiring type per zone as well. Quote Link to comment Share on other sites More sharing options...
sixwheeledbeast Posted August 2, 2017 Share Posted August 2, 2017 You don't need to Link out T just make sure it's programmed as Normally Closed. Quote Link to comment Share on other sites More sharing options...
Daniel G Posted August 2, 2017 Author Share Posted August 2, 2017 Thank you for you help!!! The Keypad was not mapped. The system works fine now! Have a nice evening! Daniel Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.