Sorry to ask all these questions, but being a DIY install, I'm learning all the time.

I'm just about ready to fully power on and test my Texecom Premier install, the only thing I've not connected yet is the Bell box.

Would there be any issues leaving the Bell box unconnected until I've got everything else working and configured, and I've checked all the sensors, areas etc.

Might sound like an odd question, but I'm just a little concerned about doing system testing etc, late at night, and until I've got everything working well, I don't want to annoy the neighbours.

Thanks,

Steve

Sorry to ask all these questions, but being a DIY install, I'm learning all the time.

I'm just about ready to fully power on and test my Texecom Premier install, the only thing I've not connected yet is the Bell box.

Would there be any issues leaving the Bell box unconnected until I've got everything else working and configured, and I've checked all the sensors, areas etc.

Might sound like an odd question, but I'm just a little concerned about doing system testing etc, late at night, and until I've got everything working well, I don't want to annoy the neighbours.

Thanks,

Steve

No problem at all - wire the bellbox in when you are happy that all is working well - HOWEVER, remember to link out the bell tamper to simulate a working bellbox or you will just get a tamper fault all the time.

No problem at all - wire the bellbox in when you are happy that all is working well - HOWEVER, remember to link out the bell tamper to simulate a working bellbox or you will just get a tamper fault all the time.

QFA

Regards

Bellman