Scantronic i-kp01 Version 1 with i-on30r ??

[roydonaldson]

Hi there,

 

In the process of swapping out a first gen i-on16 with a modern i-30R.

 

It currently has a Version 1 i-kp01 keypad connected to it.

 

When powering up the kep pad is saying Press addr buttons on wired keypads.

 

I'm holding A and Tick down but it is not working.

 

Do you think this will be due to it being a version 1 keypad and it expecting to hardwire onto the bus ?

 

Thanks,

Roy

 

 

[al-yeti]

33 minutes ago, roydonaldson said:

Hi there,

 

In the process of swapping out a first gen i-on16 with a modern i-30R.

 

It currently has a Version 1 i-kp01 keypad connected to it.

 

When powering up the kep pad is saying Press addr buttons on wired keypads.

 

I'm holding A and Tick down but it is not working.

 

Do you think this will be due to it being a version 1 keypad and it expecting to hardwire onto the bus ?

 

Thanks,

Roy

 

 

It's not modern tho , discontinued so better to return or don't buy it 

 

Get the ion40 range more or less same price 

The keypad adding can be stupid , power cycle and try again 

[roydonaldson]

The i-on30R engineering manual says that it is compatible with the i-kp01 ( firmware version 2.0 or above ) and the V1 i-kp01 uses jumpers to set it's bus address. So, I'm guessing that the A, Tick option does not work on it and so it

cannot be learned by the panel.

 

I know the i-on30R is not current, but it can still get upgraded to the latest V7 firmware and connect to SecureConnect on wifi.

[roydonaldson]

Just following up on this for anyone. It was definately the old Version 1 keypad not being compatible. I just cabled up a new generation keypad to it and it worked first time.