Hi. I have a 9448 it is working perfectly all user functions work eg turn chimes on and off it sets, unsets everything good as far as user functions go. 

 

However if I try to get into engineer programing mode by 0, enter and my code it just beeps and nothing happens ie no flashing red leds nothing.

 

It has had a recent new battery and that test good under load.

 

I wonder if there is another code sequence I am unaware of I should try or is it new panel time. All help much appreciated. Thanks. John.  

16 hours ago, john. said:

Hi. I have a 9448 it is working perfectly all user functions work eg turn chimes on and off it sets, unsets everything good as far as user functions go. 

 

However if I try to get into engineer programing mode by 0, enter and my code it just beeps and nothing happens ie no flashing red leds nothing.

 

It has had a recent new battery and that test good under load.

 

I wonder if there is another code sequence I am unaware of I should try or is it new panel time. All help much appreciated. Thanks. John.  

Your engineer code is different from what your trying 

Hi al-yeti. Thanks for the reply but I am using the code I programmed in, if I use a random code or, indeed the default engineer access code #### I don't get the beep so I assume I am using the correct code. Thanks again. John.

 

PS I would try a reset but I'm worried that I would loose my settings and only the default settings would be available.

Edited August 19, 20232 yr by sixwheeledbeast
No codes in posts please