Hi guys been having some issues with this panel, it seems a bit different from most scannys I've worked on. 

 

I'm trying to send a confirmed alarm on this panel but it's in an occupied building. My first issue is trying to set 2 zones to a seperate area, in the programming menu it appears I can only set area numbers rather than the usual A, B, C, D. (Unless I'm doing something wrong) 

 

2nd problem is when I try to set a particular area that isn't the default one I get the "areas can't be accessed" come up on the keypad. 

 

Any help greatly appreciated! 

It sounds like you're dealing with a security panel that has a different setup than what you're used to. Here are a few suggestions that might help you resolve these issues:

1. Setting Zones to Separate Areas: If the panel uses numbers instead of letters for areas, you might need to refer to the user manual or programming guide specific to that model. Look for a section on area programming or zone assignment. It's possible that the panel requires you to assign zones to numerical area identifiers rather than alphabetical ones.

2. Accessing Non-Default Areas: The "areas can't be accessed" message could indicate a few things:

   • Permissions: Ensure that you have the necessary permissions or access level to modify or access different areas. Some panels restrict access based on user roles.
   • Panel Configuration: Check if the panel is configured to allow access to multiple areas. There might be a setting that needs to be enabled to access non-default areas.
   • Keypad Limitations: Some keypads are limited to controlling specific areas. Make sure the keypad you're using is configured to access the area you're trying to set.

On 04/08/2021 at 11:09, KWCFC said:

Hi guys been having some issues with this panel, it seems a bit different from most scannys I've worked on. 

 

I'm trying to send a confirmed alarm on this panel but it's in an occupied building. My first issue is trying to set 2 zones to a seperate area, in the programming menu it appears I can only set area numbers rather than the usual A, B, C, D. (Unless I'm doing something wrong) 

 

2nd problem is when I try to set a particular area that isn't the default one I get the "areas can't be accessed" come up on the keypad. 

 

Any help greatly appreciated! 

But this panel still has those settings , where are you trying to example add a zone to A or D , are you using the usual way go to specific menu?

 

What you mean by area numbers , where are you doing that ?

It maybe your doing things wrong order? Eg partitions won't work without areas right?

Edited December 26, 20241 yr by al-yeti