Texecom Premier Elite 12 Part Set Question

[secureiam]

ditto Simlec

[PSE]

Purely for testing purposes,

Change the PIR mode from Hybrid to always awake

Go through your scenario again, see if the results change

This will prove your configuration setup are or hardware

Remember to revert it back to Hybrid mode after

[Joe Doherty]

I thought guard access will cause full alarm condition if entry/exit timer has not.started. ie for a hallway pir. As the front door is not going.to be opened shouldnt it be programmed.as.timed.entry/exit zone

[Simlec]

I thought guard access will cause full alarm condition if entry/exit timer has not.started. ie for a hallway pir. As the front door is not going.to be opened shouldnt it be programmed.as.timed.entry/exit zone

If you have a read of the manual it states a Guard Access zone will start the part set entry timer when system is part set. I personally use entry/exit 2 attribute and never had a problem.

[PSE]

Probably installed ten ish texecom alarms in last 3 years and mines the only one that doesn't seem to work properly,

 

Are you really sure that its the equipment at fault,  Like others, We use lots of Texecom. I don't experience this sort of issue

I would recommend going through the manual again to get a clear understanding of the zone attributes and features

 

As above, Guard access should start the entry timer when part set. Double check all other enabled options in the menu

[Joe Doherty]

If you have a read of the manual it states a Guard Access zone will start the part set entry timer when system is part set. I personally use entry/exit 2 attribute and never had a problem.

Thanks.simlec will remember that for future only ever done premier elites on commercial jobs so never had a need to use part sets or out. If it was my house i would put a keypad in bedroom but thats personal prefernce