Quintas Posted September 19, 2014 Share Posted September 19, 2014 Hi, there. I have an Ademco-Microtech Galaxy 16plus. 1) Can I install an expansion wireless module connected to one of the free zones and use wireless GB? Does that work like that? 2) Galaxy has a personal attack (PA) function in the keypads, pressing *0, but mine doesn't work. I have 2 keypads and it doesn't work in either. The programming is OK and enabling that function. Any hints why it doesn't work? Thank you all. Link to comment Share on other sites More sharing options...
matthew.brough Posted September 19, 2014 Share Posted September 19, 2014 No chance. Way too old. A galaxy g2 can though and easy to retrofit. www.securitywarehouse.co.uk/catalog/ Link to comment Share on other sites More sharing options...
JB_ Posted September 20, 2014 Share Posted September 20, 2014 1- Whats a wireless GB? Is it glass break? If it's a single device you want to connect to a single zone on your panel then you could get a single zone receiver. Such thing as http://www.visonic.com/Products/Wireless-Property-Protection/Glass-break-detector-mct-501 and http://www.visonic.com/Products/Wireless-Property-Protection/Receiver-mcr-304 2- Keypad PA function is *2 I think, don't remember what *0 is. It's silent PA though. Link to comment Share on other sites More sharing options...
Quintas Posted September 21, 2014 Author Share Posted September 21, 2014 Thank you both for the replies. JB, that MCR-304 receiver is really what I was looking for. The MCR-308 Wireless Interface for Hard-Wire Control Panels will also do. For wireless GB I really meant a Glass Break detector. Is it that easy to jam wireless devices as I read on the net? The MCR-304 Installation Instructions themselves say that "Receivers may be blocked by radio signals occurring on or near their operating frequencies." A bit scary, no? As posted here http://www.thesecurityinstaller.co.uk/community/topic/37410-outdoor-dt-and-indoor-glassbreak/, can you confirm if GB are any good on double glazing windows (I think this is what I meant, according to the reply I got; anyway it's a window with 2 sheets of glass with air ou vacuum between them)? Regarding the PA activation button on the MK3 keypad you are right. The *2 is the only one that I can trace in the MK3 log. The *0 doesn't even leave any register. Anyway the *2 also doesn't work. It must have something to do with Outputs programming. It´s a bit hard for me to understand that since I only have an english manual with bugs after all, as I just found out (my manual says it's *0 and it should be PA, not Silent PA) but I will try again. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.