Honeywell Galaxy G2-12

[Hine1789]

Alrite guys and girls,

 

I have recently installed a Honeywell Galaxy G2-12 panel with 5 sensors. Everything seems to be working fine but I have now been asked to install two of the following sound bombs;

Quad Piezo Siren Sounder/Sound Bomb for Alarm Systems

I have now hit a brick wall as need to connect these two up. I was wondering whether anyone knows where the two cables go. There is a black(negative) and red (positive) go.

 

Please help and thanks in advance.

[matthew.brough]

Now then now then

[Hine1789]

See i tried it in +12v and 0v on the SAB part but the alsounders are continually ringing. Any help would be appretiated

[matthew.brough]

You got half of it right. Keep +12v where it is and move the neg wire to bell trigger, not -12v as you did which is why it rang constantly. Forget without looking in the manual but if you know where +/- 12v is it should be easy enough to work out.

Unless you want to take a photo of the terminals and I'll tell you which one.

[goncall]

You got half of it right. Keep +12v where it is and move the neg wire to bell trigger, not -12v as you did which is why it rang constantly. Forget without looking in the manual but if you know where +/- 12v is it should be easy enough to work out.Unless you want to take a photo of the terminals and I'll tell you which one.

second from right I think..

[matthew.brough]

Not seen a baby g2 for a while.

[goncall]

Not seen a baby g2 for a while.

you havnt seen your tool for a while either tubbs....

[matthew.brough]

You know those mirrors they have on busses like a periscope. That could help . . .

[goncall]

You know those mirrors they have on busses like a periscope. That could help . . .

try a circus one,that's what you could be like...

[antinode]

Be careful you don't exceed the current rating of the output/PSU if you already have a sounder connected. You're limited to 500mA from the bell output.