ryan042000 Posted July 6, 2012 Share Posted July 6, 2012 Hi, Does anyone have the installation manual for a chubb delta 6 bell box ? Thanks Link to comment Share on other sites More sharing options...
Lwillis Posted July 6, 2012 Share Posted July 6, 2012 what help are you after? Link to comment Share on other sites More sharing options...
ryan042000 Posted July 6, 2012 Author Share Posted July 6, 2012 The jumper settings and wiring connections also is it a dual tone sounder silly question but I live in a Adt area and hate the sound of them Link to comment Share on other sites More sharing options...
ryan042000 Posted July 6, 2012 Author Share Posted July 6, 2012 Do u know much about these sounders Link to comment Share on other sites More sharing options...
Lwillis Posted July 8, 2012 Share Posted July 8, 2012 Well I've taken quite a few of them down in recent times Don't think I've got one in the van to have a look at . Send me your panel information and I'll mock up a list of colours to use . Yes they are a dual tone but they have a high pitch compared to most sounders . They have a tamper loop connections 2 terminals And the usuall pos an neg hold off . -ve strobe and sounder triggers Link to comment Share on other sites More sharing options...
ryan042000 Posted July 8, 2012 Author Share Posted July 8, 2012 Itsa texecom panel 24 Terminals are (a)- +12v (b)- bell - ©- tamp (d)- 0v- (s) strb- Also the panel has various programable opts wich 1 is used as an eng to envoke the bell hold off during servicing I can change this from positive to negative I would also like to know what the fault terminals do and how I can utilise also I saw terminals marked foam detector is one fitted on this unit Im not sure as I don't know exactly what I'm looking for I also use colouring code for wiring which has become second nature to me it would help if you could incorporate This in for me (a) red (b) blue © yellow (d) black (s) green Eng would be white or any other color not used Also I know I would have to use extra cores for the fault terminals Reason I want to use these is I live in a ground floor flat and I hav had my sounder filled with insulation in the past To silence it wich never worked but reddused the sound quality greatly so at least I would get a heads up if it was tampered with Also where do I put the jumpers for the longest sounding and have the strobe remain on And where do I connect the piezo sounders to pz1 and 2 would the be connected in parallel or is ere a common else where Link to comment Share on other sites More sharing options...
Lwillis Posted July 8, 2012 Share Posted July 8, 2012 The 2 pizeo sounders are connected in parallel on the far right hand side can't remember what they are marked as at the minuite. I'll have a look in the office tomorrow morning to find the foam detection , tbh I've never used it and have only really removed then and replaced it with our own units . Link to comment Share on other sites More sharing options...
ryan042000 Posted July 8, 2012 Author Share Posted July 8, 2012 Ok mate for your help Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.