We have an old Sensormatic RA485LP. The only information available on the web for this ptz camera is in this forum in this thread. In my reading of that thread I pull out two useful pieces of information:

1) this is a two board unit

2) it supports AD422 protocol

We need additional information however.

3) What is the pin assignment for the orange (power/data) connector? Ours does not have the cord.

4) What additional protocols, if any, does the unit support?

5) Is there any support documentation anywhere which can be used, even if it is for another model?

Thanks in advance.

dont fall into the trap that 422 is the same as sensormatic 422, our sales dept did at a cost of 8 grand

Thank you! AD422 can also mean "RS422". Thus the request for additional info.

sensormatic/ad 422 is very similar to rs 422 but wont work correctly

I have a manual I can Email to you (PM me with your e-mail address)

The connections you need are as follows:-

Connector terminals to the top, looking at the back of the connector, pins are 1 to 7 from left to right

Pin1 - TX Low

Pin2 - TX High

Pin3 - 24Vac

Pin4 - GND

Pin5 - 24Vac

Pin6 - RX Low

Pin7 - RX High

Hope this helps

Thank you for the offer. PM sent.