Hatsumi Posted February 20, 2007 Share Posted February 20, 2007 Hello, I am replacing an old Bell Box with a Texecom Odyssey 3 Bell Box. Can anyone advise me which wire from the Alarm Control Panel goes to which connection on the Bell Box I have included photo's of the control panel and bell box. The wires from the control panel that I need help with are as follows: Strobe + Yellow Strobe - Green T (SCB) White A (SCB) Black Bell + Red Bell - Blue Any help would be very much appreciated Many Thanks, Steve. Link to comment Share on other sites More sharing options...
kka Posted February 20, 2007 Share Posted February 20, 2007 please confirm that the panel is an optima ? Kevin Scott. Owner of KK Alarms...... Installation .. Service .. Repair ...... Thoughout.. Northumberland and North Tyneside ..... Tel:01670 361948 (call diverted after 15 seconds) or 07947444114 Link to comment Share on other sites More sharing options...
Guest Alarm Guard Posted February 20, 2007 Share Posted February 20, 2007 please confirm that the panel is an optima ? Looks to me like a very early Optima 6 Link to comment Share on other sites More sharing options...
Hatsumi Posted February 20, 2007 Author Share Posted February 20, 2007 please confirm that the panel is an optima ? You are both correct, the picture shows my old control panel as I don't have a picture of my new panel which I have replaced it with. The new panel is a Optima XM XLConcept 6 but has almost the same connections as the old. I bought it for this reason, so that I could take out the old and install a new replacement. The Bell Box also needed replacing but this is where I am having the problem with identifying where the wires go? Can either of you gentlemen help me please? Thanks, Steve. Link to comment Share on other sites More sharing options...
Hatsumi Posted February 20, 2007 Author Share Posted February 20, 2007 Green to STRBBlack to 0V White to Tamp Blue to Bell Red to +12V and take the yellow out of the terminal in the control panel and tape it up or cut it off so it can't touch anything else That's great, I was confused why there was 6 wires from the control panel and only 5 in the Bell Box Just one other question, should the Bell Box have the jumper set to SCB or SAB? Thanks very much for your time Best Wishes, Steve. Link to comment Share on other sites More sharing options...
norman Posted February 20, 2007 Share Posted February 20, 2007 please confirm that the panel is an optima ?Why, are your eyes painted on?* loving the box of quick blows in anticipation! Nothing is foolproof to a sufficiently talented fool. Link to comment Share on other sites More sharing options...
Hatsumi Posted February 21, 2007 Author Share Posted February 21, 2007 Just leave it on SAB Great, I'll do that Thanks again for your advise Best Wishes Steve. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.