dra6ko

Everything set up and work fine. But the manual helped a lot.There was not a chance to make something without it.

I hope now to have more luck when I have the manual. Of course If I need your help will write again. It's shame to left it like this,because everything was mounted before years ago and just needed to be configure,but I left it like this with the idea "some day". So this day come.

Found the original manual in one bag in my home with the left sensors and other parts from the set. If anyone need it I can make some scans. Now I will try to set it up,if I have any questions I will put them in new separate thread.

I read that the unused zones must me linked,so I did this too.Now all zones are with switched off leds and only the real zones switch on when sense movement. white+black wires=normal work=switched off led.

Some update.I reconnect the wires and now the zone's LEDs are off.So the things are connected. And when I open the door zone 2 lit.And stay lit even when I close the door,because I think it need to enter the passcode to restore it. But no alarm from the horn,may be it's turned off somehow.

Here is how I wired it.Everything is marked where to be so I think there is no mistake.

So to understand the I have good contact the zone's LED must go out? Yes I have DVM,what I need to measure?And what readings I must have?

Alright this is some help for the door. What is the normal distance. And what is the right fir-arrow vs arrow or opposite.I think it's arrow vs arrow the right one.

1.How to reset the system it,may be some key combination or power loss. 2.How to set up the zones.I think mine are not set because all of them are in red. 3.How to put the passcode 4.After that to set up the time need for enter passcode 5-10-15sec.

These are not answers for help. I need help.The system is working it need to be just set up nothing more,and I need someone that can help me or upload/pay for the manual.

Here are some pics. How is the right position of the door sensor? And the current state of the control panel. Use two sensors and they are connected in Zone 7 and Zone 6 as like their labels. But the door sensor don't have any zone label.Currently is in Zone 1,but I don't know. What mean when the sensor's LED flashes in red? Tested the horn and it work fine when I release the button at back of the control panel. Battery status is low because I use power supply for the tests.The batteries are removed. I'm not newbie with the electronics and computers so with little help will do the things. I have this system from 5-6 years and now it's time to use it.So sorry that I didn't hold the manual.

Yes,everything is set up. I just want to know how to configure the password. Want to make it when sense the door is open to wait 5-10sec until I enter my password.If this have option for that or is some default value/ And how to reset all settings.I hope removing the battery will help,because like child,stupid me,I just pushed some buttons and didn't know exactly what I entered. Nothing special as you can read.

I just need some help nothing more. If I need to pay some $$ I can do it. Regards

Sorry that I up this old tread but can someone help me with finding manual for this system. If someone can send it to me or upload it will be very cool. I can provide my e-mail. Regards to everyone