mcelec

There are a few versions of the software knocking about however as stated previously you will need a system that can run DOS and also have a internal floppy drive, and the other issue is if it is version 13. as this is dongle protected and so you are unlikely to get your hands on a dongle. The other problem is even if you got the software it is not straight forward and you really do need to know what your doing

Thanks guys appreciate the advice, CAME actually have a office in Stockport which is only 40 mins away from us

Hi Guys Thanks for replying, I have spoke with the engineer that went out to site he tried linking out the sensors, Im going to try and get a cost for the ZA4 board and swap that and see how we get on.

Not sure if this is the right place to post...... One of our good clients has asked if we could at a electric gate as a favour, basically it is stuck open. I have sent one of our engineers along he has checked all the usual voltage etc, all appears fine he seems to think it may be the board controlling the gate Quadro Commando ZA4 - does anyone know where you can get hold of one of these and cost? Anyone have any experience on gates have any suggestions? It really is one of them jobs where you wish you stuck to your guns and stuck with sorry we don't do gates

there are versions about but you need to know which version is used on the site as they are not backwardly compatible (have a look at the chip on the loop card it will have the version number on it) The lead is easy enough to make but if you have no previous experience in using consys it may be worth avoiding it as there is specific ways to do uploads/downloads when you need to fit pins etc, the last thing you want to do is render the system in-operable because you will lose the client and then get a big bill of //.Large National Installer.// to correct the panel. if its just 1 or two devices to be programmed you may be wiser getting //.Large National Installer.// in and just add your margin onto there cost!