kwak Posted August 7, 2007 Share Posted August 7, 2007 We have an old Sensormatic RA485LP. The only information available on the web for this ptz camera is in this forum in this thread. In my reading of that thread I pull out two useful pieces of information: 1) this is a two board unit 2) it supports AD422 protocol We need additional information however. 3) What is the pin assignment for the orange (power/data) connector? Ours does not have the cord. 4) What additional protocols, if any, does the unit support? 5) Is there any support documentation anywhere which can be used, even if it is for another model? Thanks in advance. Link to comment Share on other sites More sharing options...
camerabloke Posted August 7, 2007 Share Posted August 7, 2007 dont fall into the trap that 422 is the same as sensormatic 422, our sales dept did at a cost of 8 grand Eucam Security Systems 0845 4630 746 www.eucam.co.uk Link to comment Share on other sites More sharing options...
kwak Posted August 7, 2007 Author Share Posted August 7, 2007 Thank you! AD422 can also mean "RS422". Thus the request for additional info. Link to comment Share on other sites More sharing options...
camerabloke Posted August 7, 2007 Share Posted August 7, 2007 sensormatic/ad 422 is very similar to rs 422 but wont work correctly Eucam Security Systems 0845 4630 746 www.eucam.co.uk Link to comment Share on other sites More sharing options...
Matt the Teckie Posted August 8, 2007 Share Posted August 8, 2007 I have a manual I can Email to you (PM me with your e-mail address) The connections you need are as follows:- Connector terminals to the top, looking at the back of the connector, pins are 1 to 7 from left to right Pin1 - TX Low Pin2 - TX High Pin3 - 24Vac Pin4 - GND Pin5 - 24Vac Pin6 - RX Low Pin7 - RX High Hope this helps Link to comment Share on other sites More sharing options...
kwak Posted August 8, 2007 Author Share Posted August 8, 2007 Thank you for the offer. PM sent. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.