Hi All

 

We've had a few of these issues over the last few years, A tamper / poll error on the micro sensors. It will repeatedly happen until I replace the batteries even if the system shows the batteries as OK.

 

Happened again last night. Here's snap shot of the log, but not sure why it's showing bell tamper as well.

 

Any advice much apprecitated.

 

 

We do get a fair few radio jamming alarms, always have. 

Clearly a few things are wrong here.

The jamming is the most difficult to resolve in finding the source of the jamming.

However, I would be concerned with the whole installation if a bell tamper occurs on activation.

Could be overload, something wired wrong, switch inside the bell; a number of things.

Time to get the multimeter out and ricochet monitor setup, assuming it's a self install.